Potassium hydroxide generally needs to be transported to the conveyor to transport the materials. In addition, the conveyor is also required for the transportation of products during packaging. However, sometimes some large blocks may be mixed in the transported materials, so what should be done to avoid the blockage of the conveyor.

我們在想辦法避免輸送機出現堵塞情況之前需要了解一下可能會導致堵塞的一些情況，比如說操作的時候沒有按照正確的方法來進行操作那么可能會導致堵塞，還有就是進行輸送的物料輸送過大導致設備負載運轉那么設備再承受不住的時候就可能會導致出現堵塞的情況。

Before we try to avoid the blockage of the conveyor, we first need to understand some conditions that may lead to the blockage. For example, if the operation is not carried out according to the correct method, it may lead to the blockage, In addition, if the conveying material is too large, resulting in the equipment load operation, then the equipment can no longer bear it, it may lead to blockage.

所以一般正常情況下使用的時候只需要控制好輸送的氫氧化鉀一般都是不會出現堵塞情況的，不過也是需要避免出現設備空轉沒有物料進行輸送的情況，因為在這種情況下雖然不會導致出現堵塞的情況，但是會直接的對設備軸承造成比較嚴重的損壞。

Therefore, in normal use, it is only necessary to control the transported potassium hydroxide. Generally, there will be no blockage. However, it is also necessary to avoid the situation that the equipment is idling and there is no material for transportation, because in this case, although there will be no blockage, it will directly cause serious damage to the equipment bearings.

而在使用的時候控制好添加物料的輸送其實就是非常重要的，但是其實我們都是知道如果人工進行添加的話這個計量是很不好控制的，所以在這一種情況下我們就可以選擇安裝一個給料器就可以很好的調整添加的計量。

In fact, it is very important to control the transportation of added materials when in use, but we all know that this measurement is very difficult to control if added manually, so in this case, we can choose to install a feeder to adjust the added measurement.

上面介紹的就是氫氧化鉀怎么避免輸送機堵塞，因為如果有某一個部分出現了卡殼其實對于整個流程來說都是會有阻礙的。

The above introduction is how to avoid the blockage of potassium hydroxide conveyor, because if a certain part is stuck, it will hinder the whole process.